Designed to seamlessly bolt onto the back of the fork, the ProGuard mudguard offers a clean installation and great coverage for mud protection.
Utilizing the threads at the back of fork brace the Proguard simply bolts in place so you can say good bye to zip-ties.
Easily set up the perfect tire clearance with the tilt brackets supplied.
The ProGuard BOLT ON has many design features, take a look at the information below:
DESIGN FEATURES IN MORE DETAIL
The sides of the mudguard are flared out to touch and hold onto the fork to dampen resonance and create more stability, thick rubber pads have been included for the sides of the mudguard to protect the fork
We had to design and manufacture our own custom M3 bolt as we couldn’t find one good enough to offer the wide clamping force and durability we needed. The following bolts come supplied in the packaging:
- M3 x 2 (FOX / MARZOCCHI)
- M4 x 3 (OHLINS)
- M6 x 1 (SR SUNTOUR)
We have included two TILT BRACKETS that just clip onto the front of the bracket allowing you to raise or lower the front for a better angle if needed, if any finer tuning is needed just zip the end you want to lower against the wheel and leave overnight
2 Allen keys have been provided in the packaging at just the right length to help you fit the mudguard
The raised rear flick was designed to simply offer a little bit more protection without adding extra length, it prevents more mud and spray from flying up the side of the frame especially when the wheel is turned
The centre indent is a nice easy reference to apply our coloured stickers to, this indent also prevents the sticker from sitting proud on the surface of the guard which would leave it vulnerable to durability issues. The adhesive used is very special and super strong and can be jet washed
Our widely acclaimed Seal Shield offers greater protection for your fork seals from high velocity mud and spray lengthening service intervals
We make our mudguard material thicker than the competition out there which together with our unique polypropylene mix allows massive impact protection, flexibility, and importantly cold weather durability and strength.
NB: If you don’t like the gloss highlights then spray the mudguard with GT85 and rub, this will remove the high gloss finish
Additional full bolt packs can be purchased should you need them
SLEEVE PACK – SR SUNTOUR - ORDER HERE
Some SR Suntour forks have a straight through UNTHREADED hole in the centre of the fork brace, you can purchase a sleeve pack that allows you to fit the ProGuard BOLT ON to the fork